3.16. Drive flywheel / plate

Removal

PERFORMANCE ORDER
1. Remove the engine or the transmission.
2. Remove coupling.
3. Record a flywheel from a provorachivaniye, having established a clamp on a gear wreath of a flywheel. Apply combination tags on a flywheel and a bent shaft.
4. Unscrew bolts of fastening and remove a flywheel.

Check

Measurement of length of a bolt of fastening of a flywheel
 d – minimum diameter of a bolt,

d = 8 mm,

L – maximum length of a bolt,

L = 22,5 mm


PERFORMANCE ORDER
1. On models with the mechanical transmission check a flywheel for wear from coupling and a condition of teeths of a gear wreath of a flywheel.
2. On models with the automatic transmission check a condition of the drive of the hydrotransformer and a gear wreath.
3. Measure length of a bolt of fastening of a flywheel to the bolt head basis (see the drawing). If length of a bolt exceeds admissible limits, it is necessary to replace bolts in a set.

Installation

PERFORMANCE ORDER
1. Clear the interfaced surfaces of a flywheel and a bent shaft.
2. Establish a flywheel according to earlier put tags, at the same time it has to be established on the directing pin, and fix by bolts.
3. Record a flywheel from a provorachivaniye and finally tighten bolts of fastening of a flywheel.
4. Establish coupling.
5. Install the engine or the transmission.