5.19. Replacement of sealing rings


Removal of laying from drive platinum

Removal of a plate of the drive on models with the automatic transmission

Measurement of length of a bolt of fastening of a plate of the drive

Sealing ring of the camshaft operating exhaust valves on models with system of injection of CIS fuel

PERFORMANCE ORDER
1. Remove a krylchatka of the fan of a radiator and the hydraulic coupling.
2. Remove a plastic casing from a forward cover of a head of the block of cylinders.
3. Disconnect the central high-voltage wire from an ignition distributor cover.
4. Unscrew bolts, uncover and move towards the ignition distributor, without disconnecting from it other high-voltage wires.
5. Unscrew screws and remove an ignition distributor rotor.
6. Unscrew the central bolt and remove the distributor rotor drive from a camshaft end face.
7. Remove the filter and laying from the top cover of a driving chain.
8. Using a screw-driver edge, remove an old sealing ring.
9. Alternatively drill two small openings located in the opposite ends of a sealing ring in a sealing ring. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws.
10. Clear a nest of a sealing ring.
11. To exclude damage of working edges of a sealing ring at its installation, wind a camshaft end face with an adhesive tape.
12. Using a tubular mandrel of the corresponding diameter, establish a new sealing ring.
13. Remove an adhesive tape from a camshaft end face.
14. Further installation is made in the sequence, the return to removal.
15. Forward sealing ring of a bent shaft.
16. Remove a pulley of a bent shaft / a quencher of tortional fluctuations and a nave.
17. Measure depth of installation of a sealing ring.
18. Using a screw-driver edge, take a sealing ring.
19. Alternatively drill two small openings located in the opposite ends of consolidation in a sealing ring. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws.
20. Clear a nest of a sealing ring.
21. Not to damage working edges of a sealing ring at its installation, wind with an adhesive tape a forward end face of a bent shaft.
22. Dip a new sealing ring into pure engine oil and, using a tubular mandrel of the corresponding diameter, establish a new sealing ring in a nest on earlier measured depth.
23. Remove an adhesive tape from an end face of a bent shaft.
24. Establish a pulley of a bent shaft / a quencher of tortional fluctuations and a nave.

Back sealing ring of a bent shaft

PERFORMANCE ORDER
1. Remove a drive flywheel / plate.
2. Replace a back sealing ring of a bent shaft in the same way, as well as a forward sealing ring of a bent shaft. After removal of a sealing ring check the surface of a bent shaft contacting to a sealing ring and at wear of this surface of a bent shaft, the bent shaft needs to be replaced.
3. Establish a drive flywheel / plate.