| 1. Open a cowl and establish it in vertical position. Establish on a partition of a motor compartment a thin steel sheet to protect перегород ку when performing further work. |
| 2. Tighten the emergency brake, then lift a forward part of the car and record on supports. |
| 3. Release a back part of the exhaust system from rubber suspension brackets and, using a soft wire, tie up the exhaust system 500 mm lower than its starting position. |
| 4. On models when carrying out further works be careful with an additional heater not to damage the cooling system hose located in a back part of a motor compartment. |
| 5. Install the selector lever in situation N. |
| 6. Working under the car, remove a bracket of fastening and remove draft from the lever of the choice of transfers. |
| 7. Unscrew and remove an arm of fastening of the exhaust system from the transmission. |
| 8. Establish a jack with wooden whetstone under a back support of the power unit and raise a jack so that the weight of the power unit was perceived by a jack. |
| 9. Unscrew a back support of the power unit from the car bottom. |
| 10. Being careful, lower a jack so that the fallen back part of the transmission provided access to the switch of blocking of a starter and lamps of a backing. When lowering the transmission do not damage the details and knots located in a back part of a motor compartment. |
| 11. Release a bracket which fixes a trosprivoda of a speedometer to the transmission. |
| 12. Turn the fixing bracket up, then disconnect the electric socket from the switch of blocking of a starter and lamps of a backing. |
| 13. Unscrew two screws and remove the switch of blocking of a starter and lamps of a backing from the transmission. |